OK. Let's get the basic information out of the way that often lacks in reviews. My dishwasher is a 2012 Kenmore Elite, model 665.1392. The literature that came with the machine says "665.1392*, 665.1394*". My diverter motor has the part number W10056349. The instructions say to go to a youtube page and watch a video. The video tells you to take out all the sprayer pieces from inside the machine. You don't need to do that with mine, which I find out later. Maybe on some machines you have to do all that, but not mine.All I had to do was turn off the power, turn the machine on its side, unplug two plugs on the diverter motor(they have clips on them), unscrew the two screws holding the diverter motor in place, unclip and take off the diverter motor.The grommet seal is NOT on the diverter motor for mine. It was in the dishwasher. I used a small pick to gently pull it out. I cleaned up the space, added oatey silicone grease to the grommet(around the outside), cleaned up the diverter motor, and put the grommet in the dishwasher. I used a socket that was just a but smaller in diameter than the seal to make sure the seal was good and pushed into that space...but not a lot of pressure. I put the diverter motor back in and attached the two plugs. Turned the power back on after putting the dishwasher back into its space.I ran 2 loads of dishes through the cycles. ZERO leaks. Wow! Incredible fix. So easy. I saved more than $150 on the service call...if they had just changed only the seal. Very pleased with the fix so far. I'm hoping it lasts a number of years. FYI. I installed the seal just like the vendor says, too. SPRING SIDE away from you. That is...the spring side should go toward the dishwasher. Some people did it the other way.